User`s guide

english
54MIPS User’s Guide – Masking
Note! To add the last line connecting the fi rst and last control point, it is important select
both of the control points required to encapsulate the calibration area (Figure 11-44). To
select multiple points, either press and hold Ctrl while using the mouse point to select
points or drag and drop a selection rectangle over the points. Finally click
(Add) again
to add the last line.
Figure 11-44. Clipping area complete.
Finally, go to online mode to see the results.
Removing clip areas
To remove a masked (clipped) area, select a complete area by performing a drag and drop
selection over a given area. Individual points can also be select by pressing and holding Ctrl
while selecting with mouse pointer.
Click “Remove” in the Calibration Panel Toolbar to remove the area(s) selected. Individual
lines in an area can also be selected and removed.