User`s guide

www.projectiondesign.com
english
49
To create the next side in the zone, click on one of the control points in the fi rst line created
(not the Bezier points) and then click “+” (Add) again (Figure 10-38). This will add other line to
the calibration panel. Continue to add lines as needed. All these lines have the same controls
as Bezier lines in the Mesh Bezier Warp and the Advanced Edge Blending.
Figure 10-39. Connecting the first and last Black Level Management points.
Important! To add the last line connecting the fi rst and last control point, it is important select
both of the control points required to encapsulate the calibration area (Figure 10-39). To
select multiple points, either press and hold Ctrl while using the mouse point to select points
or drag and drop a selection rectangle over the points. Finally click “+” (Add) again to add the
last line.
Removing BLM zones
To remove a BLM zone, select a complete zone by performing a drag and drop selection
over a given zone. Individual points can also be select by pressing and holding Ctrl while
selecting with mouse pointer.
Click “Remove” in the Calibration Panel Toolbar to remove the zone(s) selected. Individual
lines in a zone can also be selected and removed.