User`s guide

www.projectiondesign.com
english
45
Grid (Pixel) test pattern
A grid with much smaller cells than the calibration grid can be really convenient for setup.
Especially when using the Mesh Bezier Warp where it calibration can be done with very few
control point.
To add a Grid (Pixel) select the “Grid (Pixel)” tab and specify your parameters (). The
parameters are: offset (x, y in pixels for top, left corner) and height and width of the cells in
the grid. Use the offset function to make grids in multiple MIPS units to overlap. See Figure
9-33
Figure 9-33. Grid (Pixel) test pattern