Manualshelf

User`s guide

ManualsBrandsProjectiondesign ManualsProjectorAction one mk III
31323334353637383940
www.projectiondesign.com
english
39
Figure 8-26. Adding a blend zone.
The “Add Blend Zone” window in Figure 8-27 will appear. Confi gure the initial parameters for
the blend zone and click “Add Blend Zone” to add it to the UI. “White” means the location
of the full on side of the blend zone (white line). “Black” means the location of the full off side
of the blend zone (black line). These blend zone will be completely disconnected from the
warping and should hence be applied after the geometry correction is complete.