User`s guide

english
24MIPS User’s Guide – Getting to know the GUI
Figure 6-12. EDID Administration.
MIPS calibrator – Calibration View
When all MIPS units are added to the project in the Device View, switch MIPS Calibrator to
“Calibration View”. This is done by clicking the “Calibration View” button in the top-left corner.
Clicking the same button in Calibration View mode will bring you back to Device View. See
Figure 6-13.
Figure 6-13. Switching views from Calibrator view to Device view and back.
Using the Calibration View Toolbar (CVT)
Like in Device View, Calibration View has its own toolbar on the left hand side of the screen.
This is called the Calibration View Toolbar, CVT. The toolbar can be shown with or withour
help texts, Figure 6-14. To enable the help texts, click the question mark.