User Manual

IMPORTANT SAFETY INFORMATION

Please read this instruction thoroughly before installing the product.

WARNINGS

• This charger is designed for indoor use only

• Do not disassemble the controller. Take to a qualified person if the unit requires repairing

• Lead acid batteries can be dangerous. Ensure no sparks or flames are present when working

near batteries

• Eye protection should always be used. Never short circuit the battery

• Given sufficient light solar panels always generate energy even when they are disconnected

• Accidental ‘shorting’ of the terminals or wiring can result in sparks causing personal injury or

a fire hazard. We recommend that you cover up the panel(s) with some sort of soft cloth so

you can block all incoming light during the installation. This will ensure that no damage is

caused to the Solar Panel or Battery if the wires are accidentally short circuited

• Always install a battery fuse on each circuit including the solar controller

• Do not reverse connect the wires to the solar panel or battery

MOUNTING THE DEVICE

The Solar Controller is mounted as below.

The quickest and easiest way to mount the unit is to use self tapping screws and mount the

unit via the four screw holes located on the mounting wings, affix to a flat surface.

12/24 Volt

45 AMP

SOLAR CHARGE CONTROLLER

MENU SET

USB

5V Max. 2.4A

Temp.

Sensor