INTELLI-RV 12V POWER MANAGEMENT SYSTEM P/No.
IMPORTANT SAFETY INFORMATION Please read this manual thoroughly before use and store in a safe place for future reference. WARNINGS ß ([SORVLYH JDVHV 3UHYHQW öDPHV DQG VSDUNV 3URYLGH DGHTXDWH YHQWLODWLRQ GXULQJ FKDUJLQJ • Before charging, read the instructions • For indoor use. Do not expose to rain ß )RU FKDUJLQJ OHDG DFLG EDWWHULHV 21/< RI WKH VL]H YROWDJH VSHFLõHG LQ WKH VSHFLõFDWLRQV WDEOH • Always charge the battery on the correct voltage setting.
CONTENTS 1. INTRODUCTION 1.1 Features 1.2 Monitor :DWHU WDQN SUREH 2. KEY FEATURES AND FUNCTIONS 2.1 Multiple inputs 2.2 Battery charger of stationery/service battery 2.3 Vehicle battery charger 2.4 Power supply mode 2.5 MPPT solar charger controller 9ROWDJH FKDUJLQJ UHOD\ 9&5 2.7 Categorised outputs 2.8 Battery low voltage protection 2.9 Manual battery switch 2.10 Precise battery measurement 2.11 Silent mode 4 5 6 6 6 6 7 7 7 8 8 8 8 8 3. STRUCTURE AND INSTALLATION 9 3.
1. INTRODUCTION 30 LV GHVLJQHG IRU XVH LQ FDUDYDQV RU PRWRU KRPHV 7KH XQLW KDV LQWHJUDWHG IXQFWLRQV VXFK DV EDWWHU\ FKDUJHU GLVWULEXWLRQ EORFNV 0337 VRODU FKDUJHU FRQWUROOHU FKDUJLQJ UHOD\ /RZ 9ROWDJH 'LVFRQQHFW /9' ZDWHU SXPS FRQWUROOHU ZDWHU WDQN LQGLFDWRU DQG /&' Display. The PM300 is designed for an easy installation and a user-friendly interface. SYSTEM COMPONENTS: 1. Master Power Unit 2.
1.
1.2 Monitor The monitor is a digital control center for complete on-board power. Optional Bluetooth module is available for remote monitoring through a smart phone. FEATURES: ß 7 %XV GHVLJQ FDQ EH FRQQHFWHG WR PXOWLSOH GHYLFHV • System monitoring ß &RQõJXUDWLRQ Figure 3 Overview of Monitor 1.3 Water Tank Probe For PM300, a maximum of 4 probes can be monitored.
10 days 11.
2.7 Categorised Outputs The 14 outputs are categorised into groups and controls as per below: TYPE QTY DESCRIPTION POSSIBLE LOAD SUITABLE Class A1 1 Relay controlled output with fuse, protected by main master switch relay Water pump Class B 10 Fused outputs, protected by master switch relay Ventilation fan etc Class C 2 Live load Fridge, security alarm etc. Class D 1 Permanent on load Auto step Table 2 Categorised outputs Figure 7 Categorised output 2.
3. STRUCTURE AND INSTALLATION 3.
Figure 9 Dimension of PM335 (Unit: mm) Installation: PM335 can be installed on a horizontal surface or vertically on a wall. Please see following instructions: Ensure clearance on both sides of PM335 unit upon installation. A recommended clearance of 5cm on each side. Figure 10 Installation of PM335 (Unit: mm) 3.
Figure 12 Installation of Monitor PMLCD (Unit:mm) 3.3 Water Tank Probe 3.3.1 PMWS400 Water Tank Probe Installation Figure 13 Dimension of PMWS400 (Unit:mm) Figure 14 Installation of PMWS400 3.3.
4. WIRING 4.1 Material CODE 1 2 3 4 5 6 7 10 11 12 13 14 15 16 17 NAME MODEL/LENGTH QTY P/NO.
4.
4.3 Preparation PM300 system is designed with concept of ‘Plug in and Play’ in mind. To complete the easy installation, a screw driver and DC cables are UHTXLUHG )ROORZ 7DEOH UHFRPPHQGDWLRQ IRU PLQLPXP ZLULQJV CURRENT MINIMUM CABLE SIZE 0–5A 5–10A 10–15A 15–20A 20–25A 25–30A 1.0mm2 or 18 AWG 2.0mm2 or 14 AWG 3.0mm2 or 13 AWG 4.0mm2 or 11 AWG 5.0mm2 or 10 AWG 6.0mm2 or 9 AWG When running cables, if they pass through panels or wall, ensure the cables are protected from damage by sharp edges.
5. DISPLAY 5.1 PM300 Power Management System P/No. PM335 Figure 21 An overview of PM335 No. LED COLOUR STATUS DESCRIPTION 1 Mains GREEN 2 Str Bat GREEN ON OFF 4XLFN öDVKLQJ öDVK WZLFH HYHU\ VHFRQG ON 6ORZ öDVKLQJ öDVK RQFH HYHU\ VHFRQG AC input OK AC disconnected AC input abnormal Alternator charging the SERVICE battery Starter battery is >13.4V and is being charged by the PM335 The Starter Battery is 2~13.4V or >16.0V, while AC power is connected. Starter battery is disconnected.
5.2 Monitor Time Date TBA Water tank 1 Temperature Water tank 2 Output power Water tank 3 Water tank 4 Charging state Service battery:Type/Capacity Power Source Solar charge Service battery: Voltage/Current/Time to go Service battery SOC (State of Charge) Water pump Alarm error code Voltage of vehicle battery VCR connection Silent/Esc switch Light/Enter/Setting switch Pump/Up switch Load /Down Switch Figure 22 An overview of monitor 5.2.1 Monitor Symbol Explanation No.
5.2.2 Switch Explanation SWITCH FUNCTION SILENT & Stop the fan ventilation in order to reduce the noise Press ‘Silent/Esc’ button until shows on the Refer to 3.11 screen, then press ‘Light/Enter’. To switch on/off pump Pump on: Pump off: PUMP & DESCRIPTION LIGHT The detailed steps are shown as below Figure 23 To switch off all the loads connected on DC charger The function is the same as load switch in PM4SW10.
6. OPERATION ,I WKHUH LV FRQöLFW EHWZHHQ WKH FRQõJXUDWLRQ RQ 30 DQG WKH PRQLWRU WKH PRQLWRU ZLOO öDVK DV D UHPLQGHU &RQõJXUDWLRQ RQ 30 &RQõJXUDWLRQ RI WKH EDWWHU\ W\SH DQG FDSDFLW\ FDQ EH GRQH ERWK WKURXJK WKH 0RQLWRU DQG WKH 30 PDVWHU SRZHU XQLW 6.1.
6.1.
0RQLWRU &RQõJXUDWLRQ 0HQX Figure 28 Main menu of setting Figure 30 Battery Type setting Figure 32 Low Voltage Protection setting Figure 34 Restore factory setting 20 Figure 29 Date and Time setting Figure 31 Battery Capacity setting Figure 33 Water Pump Enable/Disable setting )LJXUH 8SGDWH õUPZDUH
6.3 MAINTENANCE 6.3.1 Battery Monitor Maintenance There is a built-in battery measurement in the PM300 system. To assure the accuracy, maintain the system with the following instructions: )XOO\ FKDUJH WKH EDWWHU\ IURP $& JULG LQVWHDG RI 39 HYHU\ ZHHNV 2. Do a full charge to the battery every 3 months. • Charge the battery with AC grid until the ‘CHG’ LED light on PM335 unit or ‘FLOAT’ shows on the monitor Every 3 months, the monitor will display a code (8018) suggesting maintenance.
7. TROUBLE SHOOTING 7.1 L.E.D Display on PM335 No. LED COLOUR STATUS DESCRIPTION 1 Mains Green 4XLFN öDVKLQJ öDVK WZLFH HYHU\ VHFRQG AC input abnormal 2 Str Bat Green 4XLFN öDVKLQJ öDVK WZLFH HYHU\ VHFRQG The Starter Battery is 2~13.4V or >16.0V, while AC power is connected.
8. SPECIFICATION MODEL PM335 ELECTRICAL SPECIFICATIONS Grid Battery PV Nominal input voltage 9 Power factor Input current at full load Starter Battery Starter battery voltage range Service battery Service battery voltage range Charger type Open circuit voltage Max supply current Max charging current 5HOD\ VSHFLõFDWLRQ MODEL PM335 ELECTRICAL SPECIFICATIONS 240±10%VAC 50/60Hz 0.95 2.5A Battery Disconnect /9' Disconnect voltage LFP (LiFePO4 Delay off time Reconnect voltage 12VDC 12.
