Installation Guide

WARNINGS

• Explosive gases. Prevent ﬂames and sparks. Provide adequate ventilation during charging

• Before charging, read the instructions

• For indoor use. Do not expose to rain

• For charging lead acid and LiFePO

batteries ONLY (of the size & voltage speciﬁed in the speciﬁcations table)

• Always charge the battery on the correct voltage setting. Never set the charger to a higher voltage than

the battery

• Disconnect the 240V mains supply before making or breaking the connections to the battery

• The battery charger must be plugged into an earthed socket outlet

• Connection to supply mains is to be in accordance with National wiring rules

• Do not attempt to charge non-rechargeable batteries

• Never charge a frozen battery

• If the AC cord is damaged, do not attempt to use. It must be replaced or repaired by a qualiﬁed person

• Corrosive substances may escape from the battery during charging and damage delicate surfaces.

Store and charge in a suitable area

• This charger is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instruction concerning the use of the appliance by a person responsible for their safety

• Young children should be supervised to ensure that they do not play with the appliance

• If the recreational vehicle is to be put in to storage without power, please turn off the BATTERY MASTER

SWITCH. If the recreational vehicle is to be put into long term storage without power, disconnect ALL

cabling from the battery.