Manual

12
FAULTS & ERRORS
There are 6 possible error signals that may be displayed. These are explained in the
following table:
Fault Bulk Full Rejuv
(Red LCD) (Blue LED) (Green LED) (Amber LED) Fault Remedy
Solid On Flashing
––––– – – –
Flashing
– – –
Solid On Flashing
––––– – – –
Solid On Solid On
––––– ––––––
Solid On
–––––
Solid On Flashing
––––– – – –
Battery
problem has
been detected
Battery may
be faulty and may
need to be replaced
Bulk charging
has timed out
and stopped
after 24 hours
Battery may
be faulty
Move charger to
a cooler location
OR
Check fan is
working properly
Over
temperature
Check battery or
remove any load
on the battery
Soft Start has
timed out
Battery
problem has
been detected
Initiate Rejuvenation
mode. If it fails again
the battery may be
faulty
Check the clips are not
touching each other
OR
Check the clips are
correctly connected
to the battery
Short circuit
or reverse
connection
of the clips