LITHIUM START 12V EMERGENCY LITHIUM JUMPSTARTER AND PORTABLE POWER BANK P/No LS950, LS1250
IMPORTANT SAFETY INFORMATION Please read this manual thoroughly before use and store in a safe place for future reference. WARNING • Risk of explosive gas. Working in the vicinity of a lead-acid batteries can be dangerous. Batteries release explosive gases during normal operation, charging and while jumpstarting a battery. Before using this Jumpstarter, read and follow the instructions carefully. Follow all manufacturer’s instructions and warnings on the vehicle’s battery and other equipment being used.
FEATURES LS950 The LS950 is suitable for starting most 12V Petrol vehicles up to 6 litres and diesel vehicles up to 3.2litres. LS1250 The LS1250 is suitable for starting most 12V Petrol vehicles up to 7 litres and diesel vehicles up to 4.5litres. 240VAC CHARGE ADAPTOR – provides for convient charging from mains power 12V USB CHARGING – Allowing the Jumpstarter to be charged from your vehicle cigarette socket. LITHIUM BATTERY – Increased storage life and a much more compact lightweight unit.
SPECIFICATIONS P/No. LS950 LS1250 Battery Battery Type Battery Capacity Lithium Iron Phosphate 8,000mAhr 25.6Whr 2Ahr at 12.8V 16,000mAhr 51.2Whr 4Ahr at 12.
PRODUCT OVERVIEW Digital Screen Displays Vehicle and Jumpstarter Voltage Battery Clamps Connection Port Jumpstarter Charging Port 240V and 12V cigarette lighter plug chargers Premium Spark Free Clamps Micro USB Charging Lead 5
VEHICLE JUMPSTARTING INSTRUCTIONS 1. Your Jumpstarter should be charged for 8 hours prior to first use and as soon as possible after each use. 2. Before making any connections, check the Jumpstarter battery status by turning on the Jumpstarter. The Jumpstarters battery capacity should show at least 2 bars or above 60% charged. 3. Turn your vehicle’s ignition OFF before connecting the Jumpstarters clamps to your vehicle. 4.
DC CHARGING, while driving. 1. Plug the DC adaptor into the jumpstarter’s charging port. 2. Connect the Cigarette plug to the vehicles Cigarette power socket, and start the car. The LCD will now display CHARGING. 3. When the battery is charged the LCD display will show FULLY CHARGED and the jumpstarter will stop charging. 4. Disconnect the Cigarette plug to the vehicles Cigarette power socket and unplug the charger from the Jumpstarter. WHEN TO CHARGE Your Jumpstarter is shipped partially charged.
TROUBLE SHOOTING 8 PROBLEM POSSIBLE CAUSE NON STOP CRANKING scrolled on display of the LCD and beeping The jumpstarter is in over-discharge protection mode. Cranking for more than 8 seconds. 1. Press JUMPSTART button to reset the alarm, then again to resume jumpstarting. 2. Wait 2 minutes for Jumpstarter to turn off or press and hold the POWER/LIGHT button for 3 seconds to turn off. Then restart Jumpstarter. REMEDIES OVER DISCHARGE scrolled on display of the LCD and beeping.
TROUBLE SHOOTING (continued) PROBLEM POSSIBLE CAUSE USB doesn’t work 1. Improper USB connections 2. The internal battery charge is too low 1. Check the USB connections are correct 2.
FREQUENTLY ASKED QUESTIONS Q. Why didn’t my Jumpstarter start my vehicle? A. There could be a number of reasons why the Jumpstarter did not start your vehicle. Check the following: 1. Ensure the Jumpstarter battery is fully charged. 2. Ensure you have followed the correct operating procedure. Refer to page 6 (“Vehicle Jumpstarting Instructions”). 3. Ensure the vehicle operates on 12V DC 4. The vehicle’s battery may be below 2.5V, the minimum start voltage for the Jumpstarter.
NOTES 11
WARRANTY STATEMENT Applicable only to product sold in Australia Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic., telephone (03) 9730 6000, fax (03) 9730 6050, warrants that all products described in its current catalogue will under normal use and service be free of failures in material and workmanship for a period of one (1) year (unless this period has been extended as indicated elsewhere) from the date of the original purchase by the consumer as marked on the invoice.