Manual

9
REMOTE CONTROL DISPLAY (IP600 & IP1000 ONLY)
To install the remote control, insert the data plug into the data socket at the rear of the
inverter. To operate the inverter using the remote, the inverter On/Off switch
must be turned to ON.
The remote is equipped with an LCD screen identical to the inverter, as well a bi-colour
status L.E.D and audible alarm. During normal operation, the LCD screen will default to
the VOLTS display (input battery voltage). Alternative information can be displayed by
pressing the relevant buttons:
VOLTS: Displays input battery voltage
WATTS: Displays the amount of power being drawn by the appliance (in Watts)
LOAD %: Indicates the percentage of total capacity being drawn by the appliance
OFF/ON: Turns the inverter on and off (stand by mode)
In the event of a fault or error, the alarm will sound, the LCD screen will display one
of several fault codes and L.E.D will illuminate various signals. Refer to the table on
the previous page (IP600 & IP1000) for fault codes and L.E.D signals.
IP150-1000 Instruction Manual_1 3/02/12 11:01 AM Page 9