Manual

4
Absorption (Constant Voltage)
The absorption stage charges the battery to 100% by adjusting the charge rate allowing
the battery to absorb more power.
Equalisation (Calcium mode only)
Designed especially for calcium batteries, this stage returns calcium batteries to full
service by removing acid stratification of the electrolyte.
Analysis
The analysis mode tests the battery to ensure that it has taken the charge; if the battery
passes the test the charger will proceed to the float stage, but if the battery fails the test,
the charger will apply a recondition charge to try to return the battery to full charge.
Recondition
If after charging, the battery is unable to hold the charge the battery reconditioning
function is initiated automatically. This is most likely to take place on batteries that
have been deeply discharged, prior to charging. The Recondition mode will then run
for 4 hours and at the end will retest the battery. The Intelli-Charge battery charger will
perform the recondition charge up to 3 times before switching the charging cycle
to Float with an error indication.
Float
The Float stage maintains the battery at 100% charge without overcharging or
damaging the battery. This means the charger can be left connected to the battery
indefinitely.
ADJUSTABLE CHARGE RATE
The charger’s output can be adjusted to suit the size of the battery for optimum
charging.
MULTI CHEMISTRY
The Multi-Chem function allows you to set the charging profile to suit each battery’s
chemistry type (GEL, AGM, WET and Calcium). This ensures correct and thorough
charging and maximises battery performance and battery life.
POWER SUPPLY
When Power Supply mode is selected, you can safely run an appliance or load from
your battery. An appliance can also be run directly from the battery clamps if required,
for example using the charger as a memory saver when disconnecting the battery
from the vehicle.
WIRING HARNESS (IC700 ONLY)
The wiring harness allows for easy connection to vehicles that have hard to reach
batteries. Includes an inline fuse to protect the harness from accidental short circuits.
RUBBER END CAPS (IC700W ONLY)
Rubber end caps provide added durability and protection.