Product Manual

STATUS SCREEN DISPLAY SCREEN ILLUMINATION ALARM REMEDY

Incorrect Battery Voltage

Screen flashing Beeping Intermittently Check voltage of battery being jumpstarted. Ensure the jumpstarter voltage

is switched to the same voltage as the vehicle being jumpstarted

*Example only: Display shows actual battery voltage.

Reverse Connection Screen flashing Constantly On Check the jumpstarter clamps are connected correctly to the battery

Low Battery Voltage ON Beeping Intermittently Recharge jumpstarter

12V Mode: less than 12.0V

24V Mode: less than 24.0V

Low Battery Voltage OFF

Beeping Intermittently Recharge jumpstarter OR to override/cancel warning hold the BATTERY STATUS

Switched Off: less than 11.5V button while the jumpstarter is switched to the off position

Input Charge Voltage Above 30.0V Screen flashing OFF Check input charge voltage is below 30V

Jumpstarter Over Temperature Screen flashing OFF Allow jumpstarter temperature to cool down

Accessories Current Overload Screen flashing Beeping Intermittently Check current draw of appliance being used

Accessories Low Voltage Disconnect (LVD)

OFF OFF Recharge jumpstarter or press Override button

Battery Charging Bulk Timed Out Screen flashing OFF Disconnect any appliance connected to the jumpstarter. If no load is connected to

the jumpstarter the batteries may be faulty and require replacing

Positive (Red) Clamp Connected ON OFF No action required

Negative (Black) Clamp Connected ON OFF No action required

Jumpstarter Connected ON OFF No action required

Internal Battery Voltage ON OFF No action required

(Battery Status Button)

Jumpstarter Mode OFF OFF No action required

(When switched to 12V)

Jumpstarter Mode OFF OFF No action required

(When switched to 24V, HP2200 only)

UNDERSTANDING YOUR JUMPSTARTER

(Scrolling Display)

(+/- Alternating)