Product Manual

13
USING THE PROJECTA HP2012/HP2200 JUMPSTARTER
AS A POWER SUPPLY
These jumpstarter’s utilise 2 x 22Ah AGM batteries and can be used as a power supply
by connecting a cigarette lighter or accessory plug into the 12V DC socket at the front
of the jumpstarter.
It is recommended to check the battery capacity before running accessories.
Below is a list of approximate run times for various appliances.
Appliance Estimated power Estimated time*
consumption (Watts) (Hours)
Car phones, fluorescent lights 4 77
Radios, depth finders 9 54
Fridges (portable compressor style) 14 39
Camcorders, portable TVs 15 31
Electrical tools, bilge pumps 24 18
Cooler/warmers, spotlights 48 8
Air compressors, car vacuum cleaners 80 4
*Estimated time is based on a fully charged jumpstarter
IMPORTANT: OVER CURRENT & LOW VOLTAGE PROTECTION
Over Current Protection: If the power demand on the jumpstarter exceeds 20 Amps
an alarm will sound & the power to the appliance will be automatically disconnected.
Check the current draw of the appliance connected to the jumpstarter is not greater
than 20A.
Low Voltage Protection: If the jumpstarter’s battery voltage falls below 11V
while running an appliance, the appliance will be automatically disconnected. It is
recommended to recharge the jumpstarter immediately. Once the battery voltage
reaches 13V the appliance will automatically reconnect.
Note: As a result of the appliance being disconnected the jumpstarter batteries may
increase in voltage slightly above 11V. In circumstances where it is essential to keep
the appliance running the OVER RIDE button can be pressed allowing you to continue
powering the appliance for a short period of time before the 11V disconnect point
is reached again.