Specifications

POSITIVELY EARTHED

 ConnecttheBLACKlead(batteryclip)fromthechargertotheNegative(-)batteryterminal.

 ConnecttheREDlead(batteryclip)fromthechargertothevehicle’schassisawayfromthe

fuellineormovingparts.

 CONNECTIONINVEHICLE(POSITIVELYEARTHED)

STEP 3 – CONNECT TO 240V MAINS POWER

 Ensure‘CHARGERATE’dialisturnedtoOFF&connectthebatterychargerto240V

mainspower.

STEP 4 – SET BATTERY VOLTAGE

 Setthevoltageofthebatterychargerbyremovingtheblackterminalcapfromeitherthe

12Vor24Vterminalonthetoppanelofthejumpstarter.Connectthepositivebattery

cableviatheringterminaltotheappropriate12Vor24Voutlet.Ensurethebatterycharger

voltageissettothesamevoltageasthebatterybeingcharged.

STEP 5 – SET THE CHARGE MODE

NORMAL CHARGE RATE ADJUSTMENT

 Thenormalchargeratecanbeadjustedbyturningthe‘CHARGERATE’dialonthetop

paneloftheunittosetting1,2or3.Thechargerateshouldbesetaccordingtothesize

of the battery.

 Seetherecommendedchargeratesforvariousbatterysizesinthetablebelow:

 CHARGERATE  BATTERYSIZE

  DeepCycle(Ah) Automotive(CCA) Marine(MCA) Time(Hours)

 Setting1(12V) 60–180 380–1080 520–1500 7–24

 Setting1(24V) 75–220 460–1300 640–1830 7–24

 Setting2(12V) 160–460 670–2800 1340–3800 7–24

 Setting2(24V) 190–540 1130–3240 1600–4500 7–24

 Setting3(12/24V) 420–1200 2500–7200 3500–1000 7–24