Specifications

6
ASSEMBLING CHARGING LEADS TO BATTERY CLAMPS
 TheHDBC90batterychargerisshippedwiththebatteryclampsdisconnectedfromthe
positive&negativechargingleads.
IMPORTANT:
•Thenegative(Black)batteryclampmustbeconnectedtothecharginglead
connectedtotheunit.
•Thepositive(Red)batteryclampmustbeconnectedtothebarecopperend
ofthesecondchargingleadsupplied.Connecttheoppositeendofthecharging
leadtoeitherthe12Vor24Voutletonthetoppanelofthebatterycharger
viathecablelugontheendofthecharginglead.
 Toconnectboththepositiveandnegativeleadstothebatteryclampsreferto
instructionsbelow:
1.Slidetherubbercoveroffthebatteryclamphandle.
2.Loosentheboltlocatedontheoutsideofthebatteryclamphandleusinga10mmsocket.
3.Feedthebearcopperendofthebatteryclampleadthroughthebatteryclamphandle
andpositionunderneaththerectangularnutaspertheillustrationbelow.
4.Refit&tightenbolttocreatefirmconnection.
5.Slidetheplasticcoverbackoverthebatteryclamphandle.