Specifications

5
BATTERY CHARGER ASSEMBLY
 YourHDBC90isshippedwiththefollowingpartswhichrequireassemblytothemain
body of the battery charger unit:
•1xBatteryChargerHandle
•4x50mmScrews
•1xBottomStabiliserStop
•2x50mmSelfTappingScrews
•2xTrolleyWheels
•WheelAxle
•2xBlackVoltageTerminalCaps
•2x35mmWashers
•2xWheelLockingRings.
1.Placethemainbodyofthebatterychargerinanuprightposition,installthetophandle
ofthebatterychargerusingthe4x50mmscrewsasperthebelowillustration.Usea
Phillipsheadscrewdrivertotightenall4screws.
2.Laythemainbodyofthebatterychargerdownflatandfitthestabiliserstoptothe
bottomofthebatterychargerusingthe2x50mmselftappingscrewsprovided.Use
aPhillipsheadscrewdrivertotightenscrews.
3.Placethewheelaxleprovidedthroughthebottomofthebatterychargerasperthe
belowillustration.
4.Placethe2x35mmwashersoneither
endoftheaxle.
5.Fitthe2trolleywheelstoeitherendof
theaxleandsecurewiththe2xwheel
lockingring’sprovided.
6.Screwthe2xblackvoltageterminal
capsprovidedtoboththe12V&
24Voutletsonthetoppanelofthe
battery charger.