Installation Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1
2
3
4
Cap nut
Mounting screw
Mounting screw
Machine screw
Crossbar
x 2
x 2
x 2
x 2
x 1
x 3
x 2
4. Attach wire nuts (BB). Tape wire nuts (BB)
and wires together.
Wire nut
Cap nut
B
AA
B
CC
B
B
B
DD
DD
EE
B
B
BB
AA
BB
ASSEMBLY INSTRUCTIONS
5
6
6. Remove check ring (E). Place glass shade
(D) over lamp holder (C), securing with check
ring (E).
2. Based on desired length, install stems (B)
together. Then install one end of stem
assembly to lamp holder (C) and the other
end to ceiling plate (A).
3. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers, black
to the wire with smooth surface (power) and white
to the wire with longitudinal ridges (neutral).
Attach copper wire to ground wire. Helpful hint:
If necessary, attach copper ground wire to
grounded junction box.
EE
AA
CC
DD
4 5
1. Remove cap nuts (AA) from mounting screws
(DD). Attach crossbar (EE) to outlet box (not
included) using machine screws (CC). Note:
The mounting screws (DD) should protrude
away from the outlet box.
5. Place ceiling plate (A) onto mounting screws
(DD). Secure with cap nuts (AA).
Lowes.com Lowes.com
A
B
C
A
DD
AA
C
D
E