Installation Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1
2
3
4
Cap nut
Machine screw
Crossbar
x 2
x 2
x 1
x 3
x 2
4. Attach wire nuts (BB). Tape wire nuts (BB)
and wires together.
Wire nut
Cap nut
B
AA
B
CC
B
DD
B
B
BB
AA
BB
ASSEMBLY INSTRUCTIONS
5
6
6. Remove check ring (E). Place glass shade
(D) over lamp holder (C), securing with check
ring (E).
3. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers, black
to the wire with smooth surface (power) and white
to the wire with longitudinal ridges (neutral).
Attach copper wire to ground wire. Helpful hint:
If necessary, attach copper ground wire to
grounded junction box.
4 5
5. Place ceiling plate (A) onto mounting screws
on the crossbar (DD). Secure with cap
nuts (AA).
Lowes.com Lowes.com
A
B
C
A
DD
AA
C
D
E
AA
CC
DD
1. Remove cap nuts (AA) from the preassembled
mounting screws on crossbar (DD). Attach
crossbar (DD) to the outlet box (not included) with
machine screws (CC). Note: The mounting screws
should protrude away from the outlet box.
F
G
2. Attach bottom stem (G) to lamp holder (C). Then,
install stems (B) and short stems (F) based on
the desired length of the item, adding ceiling
plate (A) once nished.