Installation Guide
32
PACKAGE CONTENTS
PREPARATION
SAFETY INFORMATION
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): #10 X 2-1/2 in. Installation Screws, Phillips Screwdriver,
Drill with 3/32 in., Marking Tool, Carpenter’s Level, Tape Measure, and Studnder.
STEP 1 Vanity Top Installation
1a. Set the vanity top (A) of the vanity base (B), checking
the location of the p-trap and drain.
1b. Remove the top and install the faucet (sold separately)
per manufacturer’s installation instructions.
1c. Hand tighten the pop-up drain (sold separately) with
a wrench (not included). Be careful not to over-tighten
the pop-up drain. Over tightening may cause cracks
on the marble top.
1d. Apply a thin bead of silicone compound around the
vanity base and set the vanity top carefully in place.
Remove any excess silicone compound with a wet rag.
1e. Attach water lines to faucet and connect the p-trap
and drain (sold separately).
STEP 2 Hinge Adjustment For Door Alignment
2. The door alignment was set in the
factory, but it could have shifted
during transit. If adjustment is
needed, follow the instructions
provided in the adjacent chart.
2
adjust door height
adjust gaps between
doors and cabinet
adjust gaps between doors
STEP 3 Vanity Base Installation
3a. Place your vanity base cabinet into
the desired position.
3b. Drill through cabinet back braces
into pre-located wall studs using
a 3/32 in. diameter drill bit. Holes
should come no closer than 2
inches from any inside edge.
3c. Insert the installation screws into
the holes and tighten securely. One
screw should be located into each
vertical brace.
3b. Unit is shipped with knobs (C)
inside of the cabinet, uninstalled.
Install pulls with provided hardware.
Wall Stud Location:
Locate the wall studs with a studnder and mark where the cabinets are to be installed. To make
installation easier, remove all the doors and drawers from the cabinets before installation.
3
WARNING & CAUTION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
Failure to follow warnings and cautions could result in serious injury. Do not exceed the maximum
load capacity. Do not stand on cabinet. Use cabinet on level ground.
WARNING
CAUTION
Base cabinet supports a maximum weight of 200 lbs. Exceeding maximum weight limit will
compromise the integrity of the cabinet structure and could cause the cabinet to fail.
Do not hang from the cabinet.
INSTALLATION INSTRUCTIONS
SILICONE
1
PART DESCRIPTION QUANTITY
A Vanity Top 1
B Vanity Base 1
C Knobs 2
A
B
C
Lowes.com
Lowes.com