Installation Guide

6
B
B
INSTALLATION INSTRUCTIONS
C
A
A
Ceiling
2. Make sure the power is turned off at the source to the
recessed housing(s) where the fixture(s) will be
installed. Place the lamp replacement instructions (C)
inside the housing. NOTE: This label provides
information about replacing lamps.
Screw adaptor (A) into socket in recessed housing.
2
3. Plug base cable connector on adaptor (A) into lamp
(B).
3
1. OPTIONAL: The downlight is compatible with both 5 in.
and 6 in. housing cans. The downlight is shipped to fit
in 6 in. cans and will not need to be adjusted if the
intended housing can is a 6 in. type. For 5 in. diameter
cans, adjust the mounting jaws by removing the screw
as shown, shift each bracket in and secure in place with
the same screw.
1
Screw
position
for 6 in.
housings
Screw
position
for 5 in.
housings
Lowes.com
7
4. Check the inner surface of the recessed can to see if
there are any obstructions that may interfere with the
downlight clips. If necessary, rotate the downlight to
another position to account for obstructions before
installing. Then, carefully route wires into fixture and
push recessed kit up flush to ceiling surface.
4
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Fixture does not light.
Circuit breaker trips
when light is turned
on.
1. Power is off.
2. Incorrect wire connection.
3. Defective wall switch.
Crossed wires or power wire
is grounded out.
1. Check circuit breaker or wall switch.
2. Check wire splices.
3. Replace switch.
Verify wires are correctly connected.
Lowes.com
Default position
set for 6 in.
fixture housing
Do not modify this fixture. Any modifications may render the product unsafe.
Before cleaning your fixture, turn off the switch or power source. Wipe the lamp with a soft,
damp cloth.
•
•