Installation Guide

CARE AND MAINTENANCE

ASSEMBLY INSTRUCTIONS

• Shut off main power supply before wiping product with damp cloth or window cleaner. Do not

use abrasives.

• Bulb replacement: Use 60-watt or less standard-base bulbs or 13-watt standard-base CFL

bulbs.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Bulb won’t light. 1. Bulb is burned out.

2. Power is off.

3. Faulty wire connection.

4. Faulty switch.

1. Replace light bulb.

2. Make sure power supply is on.

3. Check wiring.

4. Test or replace switch.

Fuse blows or circuit

breaker trips when

light is turned on.

Crossed wires or power wire is

grounding out.

Check wire connections.

7. Remove the finial (F) and nut (E) as well

as rubber ring (D) from the

lamp holder

(B).

Then pass the threaded nipple of lamp holder

(B) with the chain through the glass shade

(C), and secure rubber ring (D), nut (E), and

finial (F)

• Note:

1. To use the pull chain, install the finial (F) as

instructed above. If a longer pull chain is

desired, also attach the cotton thread (FF)

to the pull chain (Fig. A).

2. If the pull chain is not desired, pull the chain

to activate the light and then cut the chain

off and install the closed finial (EE) instead.

Fig. A

Lowes.com