Installation Guide

ASSEMBLY INSTRUCTIONS

Hardware Used

x 2

x 1

Short mounting screw

Long mounting screw

Mounting bracket

ASSEMBLY INSTRUCTIONS

6. Install light bulbs (not included). Use two 60-watt

max. standard-base bulbs or two 13-watt standard-

base CFL bulbs.

Hardware Used

x 3

Wire nut

4. Attach wire nuts (AA). Tape wire nuts (AA)

and wires together.

1. Attach the mounting bracket (DD) by tightening

the short mounting screws (BB) securely

into the outlet box (not included). Attach the

long mounting screws (CC) into the mounting

bracket (DD).

3. Strip 3/4 in. of insulation from wire ends.

Twist stripped ends together with pliers (not

included), black to black (power) and white to

white (neutral). Attach copper wire to ground

wire. Helpful hint: If necessary, attach copper

ground wire to grounded outlet box.

5. Place the ceiling plate (A) over the outlet box.

Both heads of the long mounting screws (CC)

should come out through the large ends of the

key holes. Twist the ceiling plate (A) until

heads of long mounting screws (CC) slide

into the narrow end of key holes. Fully tighten

long mounting screws (CC) to secure the

ceiling plate (A).

Lowes.com

2. Pass the wires of the lamp holder (B) through the

center hole on the ceiling plate (A), then place the

spring on the lamp holder (B) into the center hole.