Installation Guide

ASSEMBLY INSTRUCTIONS
Hardware Used
Hardware Used
Hardware Used
1
2
3
Short mounting screw
Long mounting screw
Long mounting screw
Mounting bracket
x 2
x 2
x 1
x 3
x 2
1. Tighten the long mounting screws (CC) two
full turns into the holes in the mounting
bracket (DD). Then fasten mounting bracket
(DD) onto the ceiling outlet box (not included)
using short mounting screws (BB).
3. Attach wire nuts (AA). Tape wire nuts (AA)
and wires together.
Wire nut
B
BB
B
B
CC
DD
B
AA
AA
ASSEMBLY INSTRUCTIONS
4
5. Install light bulb (not included). Use two 60-watt
max. standard-base bulbs or two 13-watt standard-
base CFL bulbs.
5
6
4. Place the xture (A) over the outlet box. Allow
heads of long mounting screws (CC) to come
out through the large ends of the keyholes.
Twist xture (A) until heads of long mounting
screws (CC) slide into narrow ends of keyholes.
Tighten long mounting screws (CC) to secure
xture (A).
6. Remove knob (G), cap (F), rubber ring (D) and
washer (C) from the threaded nipple (B).
Tighten the threaded nipple (B) into
the xture (A). Place the washer (C), rubber
ring (D) and glass shade (E) onto the threaded
nipple (B). Place cap (F) onto the threaded
nipple (B) and secure with knob (G).
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers (not
included), black to black (power) and white to
white (neutral). Attach copper wire to ground
wire. Helpful hint: If necessary, attach copper
ground wire to grounded junction box.
CC
A
A
B
C
D
E
F
G
4 5
B
CC
DD
BB
CC
Lowes.com Lowes.com
or