Installation Guide
5
4
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
5
5. Install light bulbs (not included). Use three
60-watt max. standard-base bulbs or three
13-watt standard-base CFL bulbs.
Lowes.com
Lowes.com
1
2
x 1
x 1
x 1
x 1
x 1
Canopy
Ring
Chain
Screw collar loop
Crossbar
Hardware Used
B
B
B
B
B
CC
DD
EE
FF
GG
CC
DD
FF
GG
EE
A
B
C
3
3. Pull out the supply wires and supply ground
wire from the outlet box. Strip 3/4 in. of insulation
from wire ends.
Make wire connections:
•
Connect the smooth wire (marked) from xture
to the black supply wire with a wire nut (AA).
•
Connect the ridged wire (unmarked) from xture
to the white supply wire with a wire nut (AA).
•
Attach the xture ground wire to the crossbar (CC)
with the preassembled green ground screw. Then
connect it to the supply ground wire with a wire
nut (AA). Tape wire nuts (AA) and wires together with
electrical tape (not included) and carefully tuck wires
back into the outlet box.
AA
Wire nut
Hardware Used
B
AA
x 3
Hardware Used
4
x 1
x 1
x 1
x 1
Ring
Screw collar loop
Crossbar
Canopy
B
B
B
B
DD
CC
EE
GG
Mounting screw
Crossbar
x 2
x 1
Hardware Used
B
B
BB
CC
x 1
x 1Ring
Screw collar loop
B
B
DD
EE
1. Remove ring (EE) from the preassembled screw
collar loop (DD). Then, attach crossbar (CC) to outlet
box (not included) using mounting screws (BB).
Note: The threaded nipple should protrude outward.
2. Choose the desired length for chain (FF), using
pliers (not included) to remove links from chain (FF)
as needed.
Note: The top and bottom section of chain (FF) are
required.
Install pole (B) onto the steel circle (A), then install
assembly to the xture (C). Open the top link of the
chain (FF) and attach it to the screw collar loop (DD).
Pass the chain (FF) through ring (EE) and canopy
(GG). Open the bottom link of the chain (FF) and
attach it to the steel circle (A). Then weave the xture
wire and the xture ground wire through the chain
(FF), ring (EE), canopy (GG), screw collar loop (DD)
and threaded nipple of crossbar (CC).
Lift canopy (GG) up over crossbar (CC). Adjust the
screw collar loop (DD) on the crossbar (CC) as
needed until the canopy (GG) is ush against the
ceiling once tightened with ring (EE).
Note: Do not install canopy (GG) or ring (EE) yet!
GG
CC
DD
EE
BB
CC
or
4. Lift canopy (GG) up over crossbar (CC), securing by
tightening ring (EE) onto the screw collar loop (DD).