Installation Guide

ManualsBrandsProject Source ManualsPendant LightingFD11-074

ITEM #0394607

FOYER PENDANT

MODEL #FD11-074

Français p. 8

Español p. 15

ATTACH YOUR RECEIPT HERE

Lowes.comAB14607

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 1-866-389-8827, 8 a.m. - 6 p.m., EST, Monday - Thursday,

8 a.m. - 5 p.m., EST, Friday.

Serial Number

Purchase Date

Project Source

is a registered trademark

Summary of content (4 pages)

PAGE 1
ITEM #0394607 FOYER PENDANT MODEL #FD11-074 Français p. 8 Español p. 15 Project Source® is a registered trademark of LF, LLC. All rights reserved. ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-389-8827, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday. AB14607 Lowes.
PAGE 2
PACKAGE CONTENTS HARDWARE CONTENTS (shown actual size) B AA B BB B CC B DD B EE B FF B GG Ring Wire nut A B Qty. 3 Mounting screw Qty. 2 C Qty. 1 D E Crossbar (not shown to size) Screw collar loop (preassembled to Crossbar (CC)) (not shown to size) (preassembled to Crossbar (CC)) Qty. 1 Chain (not shown to size) Qty. 1 Canopy (not shown to size) Qty. 1 Qty.
PAGE 3
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 1. Remove ring (EE) from the preassembled screw collar loop (DD). Then, attach crossbar (CC) to outlet box (not included) using mounting screws (BB). Note: The threaded nipple should protrude outward. 3. Pull out the supply wires and supply ground wire from the outlet box. Strip 3/4 in. of insulation from wire ends. Make wire connections: • Connect the smooth wire (marked) from fixture to the black supply wire with a wire nut (AA).
PAGE 4
ASSEMBLY INSTRUCTIONS WARRANTY 6. Remove ball nuts (G) from the steel circle (A) and remove washer (E), rubber ring (F), plate (I), finial (J) from the threaded nipple (D). Install threaded nipple (D), washer (E) and rubber ring (F) through glass shade (H), securing with plate (I) and finial (J). Then install glass shade onto steel circle (A) with ball nuts (G).