Installation Guide

TROUBLESHOOTING

CARE AND MAINTENANCE

• Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as

these will dull the finish and void your warranty.

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Leak from under handle. Retainer nut has come loose.

O-ring on cartridge is dirty or

damaged.

Tighten the retainer nut. Clean

or replace O-ring.

Aerator has an inconsistent

water ow pattern.

Aerator is dirty or mistted. Remove aerator, check for

debris in the aerator screens,

and conrm the rubber washer

is properly installed.

Water leaks from aerator. Seats need to be replaced. Determine if the drip is hot

or cold. Disassemble correct

handle and cartridge. Remove

rubber seat from inside of the

faucet body and replace with

new one. Reassemble cartridge

and handle.

Leaks around base of spout. O-ring set should be replaced. Turn off water supply. Remove

spout trim cap. Pull spout

straight up. Replace the o-ring

set located on the body of the

faucet. Re-assemble.

Side spray does not function. Spray diverter has stopped

functioning properly.

Turn off water supply. Remove

spout trim cap. Pull spout

straight up. Remove the spray

diverter located in the body of

the faucet. Replace the spray

diverter in the same position

and re-assemble spout.

OPERATION INSTRUCTIONS

QUICK CONNECTOR REMOVAL

4. Operate side spray (B) to clear spray hose (F) of

trapped air.

1. Push quick connector housing on hose (E)

upward. Hold clip and housing together and pull

downward.

WARNING: Be careful in removal of quick

connector so as not to cut hands.