Warranty Guide

5
ASSEMBLY INSTRUCTIONS
2. Remove supply nut (I) and supply insert with O-ring
(G) from valve body (D). Attach supply nut (I) and
supply insert with O-ring (G) onto hot and cold
supply lines (not included).
Note: Use thread seal tape (AA) on all pipe threads.
Note: Numbered arrows within steps indicate
sequence of actions.
1. Shut off main water supply before installation.
3. Attach hot and cold supplies to handle valves of
the valve body (D) by tightening supply nut (I).
Recommended distance from center of pipe to
finished wall is 1-3/4 to 3 inches.
1
2
1
2
2
3
G
I
1
Thread seal tape
1
2
1
2
3
3
D
I
1-3/4 in.
to 3 in.
1-3/4 in.
to 3 in.
AA