Warranty Guide

3
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product. If you have any questions regarding the product, please call customer service at
1-866-389-8827, 8 a.m. - 8 p.m., EST, Monday - Friday.
WARNING
• Follow these installation instructions carefully. Proper installation is the installer’s responsibility.
• Check local building codes before beginning installation to ensure compliance.
• The should be installed by a licensed plumber in your state.
• This product is engineered to meet the EPA WaterSense ow requirement. The ow rate is
governed by the aerator or ow controller. If replacement is ever required, be sure to replace it with
a WaterSense compliant aerator or ow controller to retain the water conserving ow rate of this
product.
• This product might require to be installed with an automatic temperature compensating device to
reduce the risk of scalding and thermal shock. Check with the local plumbing code requirement
before installation. The product should be installed by the local licensed plumber.
• The shower shall be used with automatic compensating valve rated at 1.3 gpm(4.9 L/min) or less.
• If you use soldering for the installation of the faucet, the seats cartridges and washers will have to be
removed before using ame. Otherwise, warranty will be void on these parts.
CAUTION
Inlet ports are designed to allow for 1/2-inch copper tubing solder connection or 1/2-inch IPS threaded
coupling connection. For threaded connections, wrap thread seal tape around threaded ends before
connecting. If soldering connections, remove cartridges, seats, and springs. Connect water supply to
the pipe by soldering. Reassemble cartridges, seats, and springs. Heat damage to these parts may
occur and result in the warranty being void on these parts.
AA
Thread Seal Tape
x 1
HARDWARE CONTENTS