Installation Guide
5
ASSEMBLY INSTRUCTIONS
Note: Numbered arrows within steps indicate sequence of actions.
Note: Use thread seal tape (AA) on all pipe threads.
Remove supply nut (I) and supply insert with
O-ring (G) from valve body (D). Attach supply
nut (I) and supply insert with O-ring (G) onto
hot and cold supply lines (not included).
1. Shut off main water supply before installation.
2.
Attach hot and cold supplies to handle valves
of the valve body (D) by tightening supply nut
(I). Recommended distance from center of
pipe to î‚¿nished wall is 1-3/4 to 3 inches.
3.
1
2
1
2
2
3
G
I
1
Thread seal tape
1
2
1
2
3
3
D
I
1-3/4 in.
to 3 in.
1-3/4 in.
to 3 in.
AA