Installation Guide

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the

product. If you have any questions regarding the product, please call customer service at

1-866-389-8827, 8 a.m. - 8 p.m., EST, Monday - Friday.

WARNING

• Follow these installation instructions carefully. Proper installation is the installer’s responsibility.

• Check local building codes before beginning installation to ensure compliance.

• The should be installed by a licensed plumber in your state.

• This product might require being installed with an automatic temperature compensating device to

reduce the risk of scalding and thermal shock. Check with your local plumbing code requirements

before installation. The product should be installed by a local licensed plumber.

• If you use soldering for the installation of the faucet, the seats cartridges and washers will have to be

removed before using ame. Otherwise, warranty will be void on these parts.

CAUTION

Inlet ports are designed to allow for 1/2-inch copper tubing solder connection or 1/2-inch IPS

threaded coupling connection. For threaded connections, wrap thread seal tape around threaded

ends before connecting. If soldering connections, remove cartridges, seats, and springs. Connect

water supply to the pipe by soldering. Reassemble cartridges, seats, and springs. Heat damage to

these parts may occur and result in the warranty being void on these parts.

HARDW

ARE CONTENTS (shown actual size)

Thread Seal Tape

x 1