Installation Guide

4.
4
● Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off
or removing the fuse from the fuse box.
● To clean the fixture, use a dry or slightly dampened clean cloth.
● DO NOT uses any cleaners with chemicals, solvents, or harsh abrasives as damage to the fixture
may occur.
● DO NOT touch new bulb with bare hands as oil from skin may damage the lamp and cause short
bulb life.
● Bulb replacement: Use 75-watt max., 120-volt PAR30-base bulbs.
WARRAN TY
The manufacturer warrants this lighting fixture against defects in materials and workmanship for a
period of one year from the date of purchase. If within this period the product is found to be defective
in material or workmanship, the product must be returned, with a copy of the bill of sale as proof of
purchase, to the original place of purchase. The manufacturer will, at its option, repair, replace or
refund the purchase price to the original purchaser consumer. This warranty does not cover light
bulbs or the fixture becoming damaged due to misuse, accidental damage, improper handling and/or
installation and specifically excludes liability for direct, incidental or consequential damages. As some
states do not allow exclusions or limitations on an implied warranty, the above exclusions and
limitations may not apply. This warranty gives you specific rights and you may also have other rights
that vary from state to state.
Printed in China
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
1. Light bulb is burned out. 1. Replace light bulb.
2. Power is off. 2. Make sure power supply is on
.
4. Test or replace switch.
Light bulb will not illuminate.
5
A
CARE AND MAINTENANCE
TROUBLESHOOTING
To remove the track head (A) from the track
section, first allow the track head (A) to cool
down. Pull down on the track head (A)
connector’s locking tab, and twist until the
track head (A) disengages.
3. Incorrect wiring.
1. Incorrect wiring.
4. Faulty light switch.
5. Connector or track head
may be installed improperly.
5. Check the connections for
proper installation.
3. Check wiring connection at
power source and at track
power feed.
1. Check wiring connection at
power source and at track
power feed.
Blown fuse or tripped circuit
breaker when fixture is
turned on.
Lowes.com
Project Source is a registered trademark of LF, LLC. All rights reserved.
®