Installation Guide

1. Insert the bulb (not included) into the track head (A).

2. Position the bulb into the ring of the track head (A).

The clip will lock the bulb into place.

GROUND

TAB

GROUND

GROOVE

3. Identify ground side on the track head (A) connector

and track section (sold seperately).

Push the top portion of the track head (A) connector

into the slot of the track section. Pull down the

connector’s locking tab. Twist ground side of the

track head (A) connector toward the ground side

the track section until the track head (A) connector

snaps into place.

NOTE: The ground side of the track head (A)

connector is the side with two metal tabs. The

ground side of the track section has an indented

groove on the face and two internal copper strips.

The track head (A) can only be assembled if the

ground sides of the track head (A) connector and

the track section are aligned.

GROUND SIDE OF

CONNECTOR

ASSEMBLY INSTRUCTIONS

Lowes.com