Installation Guide

● Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off
or removing the fuse from the fuse box.
● To clean the fixture, use a dry or slightly dampened clean cloth.
● DO NOT uses any cleaners with chemicals, solvents, or harsh abrasives as damage to the fixture
may occur.
● DO NOT touch new bulb with bare hands as oil from skin may damage the lamp and cause short
bulb life.
5
4
A
● Bulb replacement: Use 50-watt, 120-volt-GU10-base bulb.
4. To remove the track head (A) from the track
section, first allow the track head (A) to cool
down. Pull down on the track head (A)
connector’s locking tab, and twist until the
track head (A) disengages.
CARE AND MAINTENANCE
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE CORRECTIVE ACTION
Light bulb will not illuminate.
1. Light bulb is burned out.
2. Power is off.
3. Incorrect wiring.
4. Faulty light switch.
5. Connector or track head
may be installed improperly.
1. Replace light bulb.
2. Make sure power supply
is on.
3. Check wiring connection at
power source and at track
power feed.
4. Test or replace light switch.
5. Check the connections for
proper installation.
Blown fuse or tripped circuit
breaker when fixture is
turned on.
1. Incorrect wiring. 1. Check wiring connection at
power source and at track
power feed.
Lowes.com