Installation Guide

11.To remove the track head (G) from the track

section (F), first allow the track head (G) to cool

down. Pull down on the track head (G)

connector’s locking tab, and twist until the

track head (G) disengages.

CARE AND MAINTENANCE

● Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker

off or removing the fuse from the fuse box.

● To clean the fixture, use a dry or slightly dampened clean cloth.

● DO NOT use any cleaners with chemicals, solvents, or harsh abrasives as damage to the fixture

may occur.

● DO NOT touch new bulb with bare hands as oil from skin may damage the lamp and cause

short bulb life.

● Bulb replacement: Use 50-watt max., 120-volt GU10-base bulb.

GROUND

TAB

GROUND GROOVE

GROUND SIDE OF

CONNECTOR

10. Identify ground side on the track head (G)

connector and track section (F). Push the top

portion of the track head (G) connector into the

slot of the track section (F). Pull down the

connector’s locking tab. Twist ground side of

the track head (G) connector toward the ground

side the track section (F) until the track head (G)

connector snaps into place.

NOTE: The ground side of the track head (G)

connector is the side with two metal tabs. The

ground side of the track section (F) has an indented

groove on the face and two internal copper

strips. The track head (G) can only be

assembled if the ground sides of the track

head (G) connector and the track section (F)

are aligned.

Lowes.com