Installation Guide

5. Tighten the track mounting screws (A) to secure
the linear track section (F) to the mounting plate (B ).
5
B
F
A
6
6. Twist the power supply (C) into the track
section (F). Secure the can opy (D) to the
mounting plate (B) by tightening the can opy
screws (E).
Note: When the power supply (C) is twisted
into position on the linear track section (F), make sure
the two copper tabs on the side of the power supply
(C) align with the two copper strips inside
the linear track section (F). This is necessary to
maintain polarity.
6
C
F
B
D
E
b. For anchor installation, drill a 7/32 in. hole at each
mark on the ceiling, and insert anchors (CC) into
the mounting surface. Insert the Phillips screws
(BB) through the track section (F) and tighten to
anchors (CC).
NOTE: Toggle bolts (AA) should be used for standard installation into drywall, drop ceiling or
suspended ceiling applications. Anchors (CC) are used for masonry installations ONLY.
4b
Hardware Used
BB
x 2
Phillips Screw
CC
x 2
Anchor
F
BB
CC
Lowes.com