Installation Guide
4
Lowes.com
®
ASSEMBLY INSTRUCTIONS
1. Prepare the bath area for installation:
a. Shut off the water supply to the tub and shower.
Note: This may require shutting off the main water
supply to your home.
b. Open the old faucet to release any potential built-
up pressure.
c. Verify that the hole sizes and position of the holes
in the wall are correct. Recommended component
measurements:
– Shower and Spout Outlet Hole: 1-1/4 in.
diameter.
– Cold and Hot Valves: 1-3/8 in. to 2 in. diameter.
– Center-to-Center Distance Between Hot and
Cold Valves: 8 in.
– Recommended Distance from Center of Valve
(Shower Outlet) to Finished Wall: 1-7/8 in. min.
to 2-7/8 in. max. The recommendation is 2-3/8
in.
Note: Do not use PEX tubing for the tub spout outlet.
1
8” Min.
30”
Tub & Shower
48”
Tub & Shower
1-3/8” ~ 2” 1-3/8” ~ 2” 1-3/8” ~ 2”
8”
2. Remove the existing shower valve. Clear any debris
from the shower and bath area. Clean old sealant from
any threaded connections.
2