Installation Guide

3.1

ASSEMBLY INSTRUCTIONS

1. Turn off water at the supply valve under the sink or at

the main water supply, disconnect the supply line, and

remove old faucet.

Clean and dry surface area where new faucet will be

mounted.

2. Place faucet (A) in position on sink so handles turn

forward. From under sink, insert rubber washers (AA)

rst and then thread mounting nuts (BB) onto faucet

(A). Tighten mounting nuts (BB). Do not overtighten.

Hardware Used

Rubber washer x 2

Mounting nut x 2

3. IF INSTALLING OPTIONAL SIDE SPRAY

Insert spray support (C) through far right hole on the

sink (3.1). Screw the mounting nut (CC) onto the spray

support (C) from underneath the sink and hand tighten

only.

Hardware Used

Mounting nut x 1

Lowes.com