Installation Guide

Lowes.com

ASSEMBLY INSTRUCTIONS

11. Attach the suction cup (FF) to the bulb (H), and

secure the bulb (H) to the socket on track head

assembly (G) by twisting and locking correctly. Detach

the suction cup (FF) from the bulb (H) by pulling the

small pin.

12. To remove track head from track, allow track head

to cool down, grasp track head connector and pull

down while twisting until track head disengages.

13. Identify ground side on track joiner (I) and loosen set

screws. Identify ground side on track sections (F) and

remove preassembled end caps from the ends to be

joined. Insert track joiner (I) into both track sections (F).

Make sure the ground on track joiner (I) are aligned with

ground side of track sections (F).

Note: The ground side of track joiner (I) is the side with

the two metal tabs. The ground side of the track section

has an indented groove on the face and two internal

copper bars. The track joiner (I) can only be assembled

if the ground sides are aligned.

Hardware Used

Suction Cup

x 1

14. Re-tighten set screws from track joiner (I).

FOR ADDING ADDITIONAL TRACK SECTIONS,

FOLLOW STEP 13 AND 14.

GROUND SIDE

GROOVE IDENTATION

GROUND TAB