Installation Guide

4
ASSEMBLY INSTRUCTIONS
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 45 ~ 60 minutes, add an additional 20 minutes if field cutting and
drilling is required.
Tools Required for Assembly (not included): Stepladder, Phillips screwdriver, Flathead
screwdriver, Wire cutters, Pliers, Safety Goggles, Drill, Handsaw
Helpful Tools (not included): Wire stripper, Electrical tape
1. If you want to field cut the track section (F), mark the
track section (F) at desired length and remove end caps.
Take into consideration the length of the connectors to be
used if any.
Secure the track section (F) and with a blunt instrument tap
on the copper strip on interior buss bars until they are
dislodged. Work on the track section (F) end that will be
cut off and disgarded. Do not remove the buss bars.
Reattach the end caps with the interior buss bars in place
and cut the track section (F) at mark. Make sure the cut is
straight with no burrs.
With one end cap in place pull the copper strips out and cut
3/8 in. off of each strip. Push the copper strips back in and
replace other end cap or make connection to other track
connector.
F
F
F
F
1
3/8 in.
3/8 in.
Lowes.com