Installation Guide

ASSEMBLY INSTRUCTIONS

2. Remove the spring (D) from track head assembly (A).

Install the bulb (C) onto the socket (B) by twisting and

locking. Position the bulb (C) inside track head

assembly (A) and secure with spring (D). See Fig. 2.

3. To remove track head from track, allow track head to

cool down, grasp track head connector and pull down

while twisting until track head disengages. See Fig. 3.

1. Identify ground side on track head assembly (A) and

track section (not included). Insert track head assembly

(A) connector into track section and twist to secure.

Make sure the ground side on track head assembly (A)

connector aligns with ground side of track section.

See Fig. 1.

Note: The ground side of track head assembly (A)

connector is the side with the two metal tabs. The

ground side of the track section has an indented groove

on the face and two internal copper bars. The track

head assembly (A) can only be assembled if the ground

sides are aligned.

GROUND

SIDE GROOVE

IDENTATION

GROUND TAB

Lowes.com