Installation Guide
CARE AND MAINTENANCE
WARRANTY
Manufacturer warrants all of its lighting fixtures against defects in materials and workmanship for
one (1) year from the date of original purchase.
This warranty does not cover parts becoming defective due to misuse, accidental damage,
improper handling and/or installation and specifically excludes liability for indirect, incidental or
consequential damages. Product found to be defective may or may not be replaced with same or
like type product, contingent on the nature of the defect, and or replacement availability and or
compensated for at a pro rated value.Some states do not allow limitations on how long an implied
warranty lasts, and/or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives you specific rights and
you may also have other rights, which vary from state to state. Proof of purchase is required to
exercise the warranty.
TROUBLESHOOTING
If you have any questions regarding the product, please call our customer service department at
1-866-389-8827, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
8
Printed in China
Lowes.com
Project Source is a registered trademark of LF, LLC. All rights reserved.
®
PROBLEM
POSSIBLE CAUSE CORRECTIVE ACTION
Light bulb will not illuminate.
1. Light bulb is burned out.
2. Power is off.
3. Incorrect wiring.
4. Faulty light switch.
5. Connector or track head
may be installed improperly
.
1. Replace light bulb.
2. Make sure power supply
is on.
3. Check wiring connection at
power source and at track
power feed.
4.
Test or replace light switch.
5. Check the connections for
proper installation.
Blown fuse or tripped circuit
breaker when fixture is
turned on.
1. Incorrect wiring. 1. Check wiring connection at
power source and at track
power feed.
● Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
● To clean the fixture, use a dry or slightly dampened clean cloth.
● DO NOT use any cleaners with chemicals, solvents, or harsh abrasives as damage to the fixture
may occur
.