Specification

Product Data Sheet
FOAMULAR
®
Project Panels
Extruded Polystyrene (XPS) Rigid Foam Insulation
• Do not leave exposed to UV/
constant outdoor exposure.
FOAMULAR
®
Project Panels
extruded polystyrene can be
affected by UV exposure, and,
if left exposed to UV for
extended periods of time, some
degradation or “dusting” of the
polystyrene surface may begin.
Once covered, the
deterioration stops, and
damage is limited to the thin
top surface layers of cells.
• Paint and glue need to be
solvent free.
• Product should not come into
contact with organic solvents.
Care must be taken in the
choice of adhesives and paints.
OWENS CORNING FOAM INSULATION, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO 43659
1-800-GET-PINK
®
ww w.owenscorningcommercial.com
Pub. No. 10017457. Printed in U.S.A. February 2013. THE PINK
PANTHER
™
& ©196 4-2013 Metro -Goldw yn -Mayer Studios Inc. A ll Rights
Reserved. The color PINK is a registered trademark of Owens Corning.
© 2013 Owens Corning. All Rights Reserved.
Disclaimer of Liability
Technical information contained herein is furnished
without charge or obligation and is given and accepted
at recipient’s sole risk. Because conditions of use may
vary and are beyond our control, Owens Corning makes
no representation about, and is not responsible or
liable for the accuracy or reliability of data associated
with particular uses of any product described herein.
Nothing contained in this bulletin shall be considered a
recommendation.
The GREENGUARD INDOOR AIR QUALITY
CERTIFIED mark is registered certi cation mark
used under license through the GREENGUARD
Environmental Institute.
This NAHB Research Center Green Approved mark
is your assurance that a product is eligible for points
toward National Green Building Certi cation. Visit
www.GreenApprovedProducts.com for details.
LEED is a registered trademark of the U.S. Green
Building Council.
*
As manufactured, Fiberglas
™
Insulation is resistant
to mold growth. However, mold growth can
occur on building materials, including insulation,
when it becomes contaminated with organic
material and when water is present. To avoid
mold growth on Fiberglas
™
Insulation, remove
any water that has accumulated and correct
or repair the source of the water as soon as
possible. Insulation that has become wet should
be inspected for evidence of residual moisture
and contamination, and any insulation that is
contaminated should be properly removed and
replaced.