User Manual

14
Getting Started
Once you’ve enabled the Project Nursery Alexa Skill, you’re ready to start using Alexa with your Smart
WiFi Baby Monitor system.
To start controlling with Alexa: Say “Alexa, open Project Nursery.” Then use one of voice commands
below. IMPORTANT: Use the name you gave your camera in the setup process—in the examples below
the camera is named “Nursery.”
Say...
Sounds /
Lullabies
“Play/stop pink noise on the Nursery camera.”
(waves and rain are also available)
“Play/stop ‘Jolene’ on the Nursery camera.”
(“Holiday” and “I Don’t Want to Miss a Thing” are also available)
Snapshots/
Video
*You must have
an SD card (not
included) in the
camera to use these.
“Take a picture with the Nursery camera.”
“Start/stop recording with the Nursery camera.”
*The camera stops recording after 1 minute unless you stop it before then.
Motion-
Sound Alerts/
Temperature
“Turn on/off Nursery camera motion/sound detection.”
“When was the last motion/sound detected by the Nursery camera?”
“What is the temperature at the Nursery camera?”
“What is the status update on the Nursery camera?”
Using Alexa (“Open Project Nursery” commands)
IMPORTANT: New voice commands are added to your Project Nursery Smart Baby Monitor System all
the time—the commands here are just a small sample to get started. For all the latest voice commands,
go to the Project Nursery Smart Camera skill in the Alexa App.