Installation Instructions

Package P

WARNING

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If

any parts are missing or faulty, contact the distributor for a replacement.

NOTE: Read the entire instruction manual before you start installation and assembly.

glass shelf(x2)

M5x10 (x6)

P-C

concrete anchor (x4)

P-B

glass holder (x2)

ST5.5x50 (x4)

P-A

connect piece(x2)

wall plate(x1)

plastic cap(x4)

P-E

decorative cover(x2)

plastic bush(x2)

P-D

3mm Allen key (x1)

P-F

• Do not begin the installation until you have read and understood all the instructions

and warnings contained in this installation sheet. If you have any questions

regarding any of the instructions or warnings, please contact your local distributor.

• This mounting bracket was designed to be installed and utilised ONLY as

specified in this manual. Improper installation of this product may cause damage

or serious injury.

• This product should only be installed by someone with good mechanical ability

who has basic building experience and fully understands this manual.

• Make sure that the supporting surface will safely support the combined weight of

the equipment and all attached hardware and components.

• If mounting to wood wall studs, make sure that mounting screws are anchored

into the center of the studs. The use of a stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position

the equipment.

• Tighten screws firmly, but do not over tighten. Over tightening can cause damage

to the items, This greatly reduces their holding power.

• This product is intended for indoor use only. Using this product outdoors could

lead to product failure and personal injury.