Installation Manual


GENERAL OPERATION
The INTELI-POWER series converter will supply
"clean" power from input voltages that range from
90-130 VAC (205-265 VAC for 230 volt models).
The INTELI-POWER series of converters are
primarily designed for use with a battery, however,
the output of the INTELI-POWER converters are a
regulated, filtered DC voltage that can power
sensitive electronics without the need for a battery or
other filtering.
At normal input voltages the full load rated capacity
is available.
At input voltages less than 105 VAC (205 VAC for
230 volt models) the converter may not supply full
rated output capacity.
9100L - The full rated load is available for load,
battery charging or both. When functioning as a
regulated battery charger the converter has a nominal
voltage output of 14.6 VDC for 12 volt models and
29.2 VDC for 24 volt models. The system is
designed to sense voltage on the battery and will taper
the charging current as the battery becomes charged.
CAUTION
The 9100L series converter/chargers are
designed to recharge lithium iron
phosphate batteries.
DO NOT USE TO RECHARGE
LEAD/ACID BATTERIES!
9100 - The full rated load is available for load, battery
charging or both. When functioning as a regulated
battery charger the converter has a nominal voltage
output of 13.6 VDC for 12 volt models and 27.2 VDC
for 24 volt models. The system is designed to sense
voltage on the battery and will taper the charging
current as the battery becomes charged.
When the vehicle is to be stored for extended periods
of time it is recommended that the batteries be
disconnected, unless a TCMS Charge Wizard
 
is
attached to the TCMS interface. Reconnect battery
once a month to maintain a full charge.
9200
- The full rated load is available for load, battery
charging or both. When functioning as a regulated
battery charger the converter has a nominal voltage
output of 13.6 VDC for 12 volt models and 27.2 VDC
for 24 volt models. The system is designed to sense
voltage on the battery and automatically selects one
of three operating modes (normal, boost and storage)
to provide the correct charge level to the batteries.
BOOST MODE: If the converter senses that the
battery voltage has dropped below a preset level the
output voltage is increased to approximately 14.4
VDC (28.8 VDC for 24 volt models) to rapidly
recharge the battery.
NORMAL MODE: Output voltage set at
approximately 13.6 VDC (27.2 VDC for 24 volt
models).
STORAGE MODE: When the converter senses that
there has been no significant battery usage for 30
hours the output voltage is reduced to 13.2 VDC
(26.4 VDC for 24 volt models) for minimal water
usage. When in storage mode the microprocessor
automatically increases the output voltage to 14.4
VDC (28.8 DC for 24 volt models) for approximately
15 minutes every 21 hours to help prevent sulfation
of the battery plates.
CAUTION
IT IS IMPORTANT THAT THE FLUID
LEVEL OF ANY CONNECTED
BATTERIES BE CHECKED ON A
REGULAR BASIS. ALL BATTERIES
WILL “GAS” AND LOSE SOME FLUIDS
WHEN CONTINUOUSLY CONNECTED
TO ANY CHARGING SOURCE
