User manual

Table Of Contents
If an option is not applicable to
a programme, the related
indicator is off or it flashes
quickly for a few seconds and
then goes out.
Activating options can affect
the water and energy
consumption as well as the
programme duration.
XtraDry
Activate this option to boost the drying
performance.
XtraDry is a permanent option for all
programmes other than . It is
automatically activated in next cycles. This
configuration can be changed at any time.
Every time is activated,
XtraDry is off and needs to be
chosen manually.
How to activate XtraDry
Press simultaneously and .
The indicator is on.
BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
After starting a programme, it may take up
to 5 minutes for the appliance to recharge
the resin in the water softener. It seems
that the appliance is not working. The
washing phase starts only after this
procedure is completed. The procedure is
repeated periodically.
The salt container
CAUTION! Use rough salt
designed for dishwashers only.
Fine salt increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening of
the salt container.
Progress 33