User manual

3. Press on/off to confirm and save the
setting.
The rinse aid empty notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying to
refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
it is possible to deactivate the notification
for refilling rinse aid. However, for best
drying performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid
empty notification
Make sure the appliance is in user mode.
1. Press .
• The indicators , , and
are off.
• The indicator still flashes.
• The indicator shows the current
setting.
– If the indicator is on = the
rinse aid empty notification is
activated.
– If the indicator is off = the
rinse aid empty notification is
deactivated.
2. Press to change the setting.
3. Press on/off to confirm and save the
setting.
The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicators , , and
are off.
• The indicator
still flashes.
• The indicator starts flashing.
The number of flashes indicates the
current setting: e.g. 4 flashes +
pause + 4 flashes... = level 4.
– The levels of rinse aid range
from 0 to 6.
– Level 0 means no rinse aid is
used. In this case the
indicator remains off.
2. Press
repeatedly to change the
setting. Each pressing of increases
the level number. After reaching level
6, the count starts again from level 1.
3. Press on/off to confirm the setting.
Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to activate
it.
How to activate the acoustic
signal for the end of programme
Make sure the appliance is in user mode.
1. Press
• The indicators , , and
are off.
• The indicator still flashes.
• The indicator shows the current
setting.
Progress 31