Operation Manual

Using the detergent
20
30
BA D
C
1. Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
Setting and starting a programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, all the programme indica-
tors come on.
If the control panel does not show this con-
dition, press and hold, at the same time,
button
and button until the
appliance is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press the button of the programme you
want to set. The related programme in-
dicator stays on while all the other pro-
gramme indicators go off.
4. Close the appliance door, the pro-
gramme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay start button again and
again until the indicator of the number of
hours you want to set comes on. You
can set 3, 6 or 9 hours.
• The delay start indicator comes on.
3. Close the appliance door, the count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time, but-
ton
and button until all
the programme indicators come on.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time, but-
ton
and button until all
the programme indicators come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
The indicator
comes on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
Important
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and on
the door of the appliance. Stainless steel
becomes cool more quickly than the
dishes.
34 progress