User manual

Problem Possible cause Solution
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The door is left open. Close the door. Refer to "Door
open alarm"
A or or symbol is
shown instead of numbers
on the Temperature Display.
Temperature sensor prob‐
lem.
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Contact the nearest Author‐
ised Service Centre.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to "Operation".
Many food products were
put in at the same time.
Wait few hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor‐
ing.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The "FastFreeze" or "In‐
tensiveCooling" is switch‐
ed on.
Refer to "FastFreeze function"
or "IntensiveCooling function".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Temperature is set incor‐
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FastFreeze" or
"IntensiveCooling", or after
changing the temperature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
32 Progress